MistyGro API
C++ API for MistyGro's ESP32 controller based on the Arduino framework
Software
esp32_firmware
src
all_off.cpp
Go to the documentation of this file.
1
// Copyright 2023 Myron Rodrigues
2
//
3
// Licensed under the Apache License, Version 2.0 (the "License");
4
// you may not use this file except in compliance with the License.
5
// You may obtain a copy of the License at
6
//
7
// http://www.apache.org/licenses/LICENSE-2.0
8
//
9
// Unless required by applicable law or agreed to in writing, software
10
// distributed under the License is distributed on an "AS IS" BASIS,
11
// WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
12
// See the License for the specific language governing permissions and
13
// limitations under the License.
14
15
#include <Arduino.h>
16
#include <FirebaseESP32.h>
// if exculded complaints about SPIFFS.h header at compile
17
18
#include "
relay.h
"
19
20
RelayAL
misters
(12);
21
RelayAL
light
(14);
22
RelayAH
extra_out
(27);
23
24
void
setup
()
25
{
26
misters
.
begin
(
Switch::ON
);
27
light
.
begin
(
Switch::ON
);
28
extra_out
.
begin
(
Switch::OFF
);
29
delay(1000);
30
}
31
32
void
loop
() {}
misters
RelayAL misters(12)
setup
void setup()
Definition:
all_off.cpp:24
light
RelayAL light(14)
Definition:
main.cpp:33
extra_out
RelayAH extra_out(27)
loop
void loop()
Definition:
all_off.cpp:32
RelayAH
Active high relay.
Definition:
relay.h:45
RelayAH::begin
void begin(Switch sw)
initialise pin and set initial relay state
Definition:
relay.cpp:19
RelayAL
Definition:
relay.h:87
RelayAL::begin
void begin(Switch sw)
initialise pin and set initial relay state
Definition:
relay.cpp:38
relay.h
Switch::OFF
@ OFF
Switch::ON
@ ON
Generated by
1.9.1